620-M7-Quiz1
Exam Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the exam before. Hence you can not start it again.
Exam is loading…
You must sign in or sign up to start the exam.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
What is the condition for a Class 3 coaxial cable assembly with 20 strands and has 3 severed shield braid strands?
CorrectIncorrect -
Question 2 of 10
2. Question
What is the condition for a Class 1 coaxial cable assembly with trim area offset of 15% of the cable diameter beyond the perpendicular angle to the center conductor?
CorrectIncorrect -
Question 3 of 10
3. Question
What is the condition for a Class 2 biaxial cable assembly that has a center conductor not visible in the inspection window prior to soldering?
CorrectIncorrect -
Question 4 of 10
4. Question
What is the condition for a Class 2 coaxial cable assembly that has a solder ferrule pin with solder buildup on the outside of the contact interfering with subsequent assembly operations?
CorrectIncorrect -
Question 5 of 10
5. Question
What is the condition for a Class 3 coaxial cable assembly that has a printed wire board mount coaxial connector with the shield piercing the sleeving?
CorrectIncorrect -
Question 6 of 10
6. Question
What is the condition for a Class 1 coaxial cable assembly that has a coaxial connector with solder buildup on the outside cover, but does not interfere with subsequent assembly steps?
CorrectIncorrect -
Question 7 of 10
7. Question
What is the condition for a Class 2 coaxial cable assembly that has a shield termination with a doubled crimped ferrule?
CorrectIncorrect -
Question 8 of 10
8. Question
What is the condition for a Class 3 coaxial cable assembly that has semirigid coaxial cables with a distance from back of the connector to start of the bend 1.5 wire diameters in length?
CorrectIncorrect -
Question 9 of 10
9. Question
What is the condition for a Class 1 coaxial cable assembly that has a semirigid coaxial cable that shows evidence of dielectric material contamination with foreign particles?
CorrectIncorrect -
Question 10 of 10
10. Question
What is the condition for a Class 2 biaxial cable assembly with a shielded wire that after stripping and during ring installation has a conductor not in contact with the surface to be soldered for the entire wrap length?
CorrectIncorrect