620-M6-Quiz1
Exam Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the exam before. Hence you can not start it again.
Exam is loading…
You must sign in or sign up to start the exam.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
Which Class of assembly requires temporary markings to be removed prior to delivery?
CorrectIncorrect -
Question 2 of 10
2. Question
What is the condition for a Class 3 assembly that has a marking that remains legible after handling, assembly, and environmental testing?
CorrectIncorrect -
Question 3 of 10
3. Question
What is the condition for a Class 1 assembly that has a flag marker with side misregistration of 5% the width of the marker?
CorrectIncorrect -
Question 4 of 10
4. Question
What is the condition for a Class 2 assembly that has a tie wrap with cut end protrusion of 1.5 times the tie wrap thickness?
CorrectIncorrect -
Question 5 of 10
5. Question
What is the condition for a Class 3 assembly with wires that twist and cross over underneath a restraining device?
CorrectIncorrect -
Question 6 of 10
6. Question
What is the condition for a Class 1 assembly with tie wraps placed over solder ferrules contained in the wire bundle?
CorrectIncorrect -
Question 7 of 10
7. Question
True or False: It is not required that each group of a broom stitch be tied with a clove hitch or equivalent knot.
CorrectIncorrect -
Question 8 of 10
8. Question
What is the condition for a Class 2 assembly that has a disturbed torque stripe?
CorrectIncorrect -
Question 9 of 10
9. Question
What is the condition for a Class 3 assembly that has a nominal safety cable diameter of 0.81mm and a minimum swaged ferrule pull-off load of 300 N?
CorrectIncorrect -
Question 10 of 10
10. Question
What is the condition for a Class 1 assembly that has an installed heat shrink tubing material that does not compromise the environmental seal of a grommet that requires sealing?
CorrectIncorrect