620-M5-Quiz1
Exam Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the exam before. Hence you can not start it again.
Exam is loading…
You must sign in or sign up to start the exam.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
What is the condition for a Class 2 assembly that has a distance of 1.5 wire diameters between the insulation end and ultrasonic weld nugget?
CorrectIncorrect -
Question 2 of 10
2. Question
What is the condition for a Class 3 assembly that has a weld nugget with individual wires distinguishable on the top and bottom compression surfaces of the nugget but without any loose strands?
CorrectIncorrect -
Question 3 of 10
3. Question
True or False: Stranded wires shall always be tinned for Class 3 product when heat shrinkable solder devices are used.
CorrectIncorrect -
Question 4 of 10
4. Question
What is the condition for a Class 1 assembly that has wires pre-tinned prior to forming a mesh splice?
CorrectIncorrect -
Question 5 of 10
5. Question
What is the condition for a Class 3 assembly that has a wrap splice with discernible wire strands?
CorrectIncorrect -
Question 6 of 10
6. Question
What is the condition for a Class 1 assembly that has a lap splice with one conductor overlapping the insulation of the other wire?
CorrectIncorrect -
Question 7 of 10
7. Question
True or False: Conductors may be twisted together prior to performing a barrel crimp splice.
CorrectIncorrect -
Question 8 of 10
8. Question
What is the condition for a Class 2 assembly that has a crimp splice using a machined contact with the pin not cut off?
CorrectIncorrect -
Question 9 of 10
9. Question
What is the condition for a Class 1 assembly that has a wire in-line junction device (Jiffy Junction) that fails contact retention verification testing?
CorrectIncorrect -
Question 10 of 10
10. Question
What is the condition for a Class 3 assembly that has a doubled sided crimp splice with wire insulation clearance of 1.5 wire diameters at each end?
CorrectIncorrect