620-M4-Quiz1
Exam Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the exam before. Hence you can not start it again.
Exam is loading…
You must sign in or sign up to start the exam.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
What is the condition for a Class 1 assembly that has a jackpost below the face of the connector and allows the connector and jackpost to mate correctly?
CorrectIncorrect -
Question 2 of 10
2. Question
True or False: Clamps are required to be tightened and fully closed to effectively secure a wire bundle.
CorrectIncorrect -
Question 3 of 10
3. Question
What is the condition for a Class 1 assembly that has a boot that does not extend to the end of the first accessory attachment area?
CorrectIncorrect -
Question 4 of 10
4. Question
What is the condition for a Class 2 assembly that has a hard face connector with chipping that does not extend from one cavity to the outer diameter of adjacent cavities?
CorrectIncorrect -
Question 5 of 10
5. Question
What is the condition for a Class 3 assembly that has a connector with contacts that are seated and locked into position?
CorrectIncorrect -
Question 6 of 10
6. Question
What is the condition for a Class 2 assembly that has an over-molded connector with an inner mold that exposes the braid and conductor?
CorrectIncorrect -
Question 7 of 10
7. Question
What is the condition for a Class 1 assembly that has an over-molded connector with an outer mold that captures 80% of the circumference of the cable jacket?
CorrectIncorrect -
Question 8 of 10
8. Question
What is the condition for a Class 1 assembly that has an over-molded connector with an outer mold that shows evidence of chill marks penetrating 25% of the depth of the outer-mold material thickness?
CorrectIncorrect -
Question 9 of 10
9. Question
What is the condition for a Class 3 assembly that has an over-molded connector with flashing that is raised 1mm but does not interfere with mechanical or electrical functionality?
CorrectIncorrect -
Question 10 of 10
10. Question
What is the condition for a Class 3 assembly that has a potted connector with no potting material on the mating surfaces of the connector?
CorrectIncorrect