610-M7-Quiz 3
Exam Summary
0 of 10 Questions completed
Questions:
Information
You have already completed the exam before. Hence you can not start it again.
Exam is loading…
You must sign in or sign up to start the exam.
You must first complete the following:
Results
Results
0 of 10 Questions answered correctly
Your time:
Time has elapsed
You have reached 0 of 0 point(s), (0)
Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)
Categories
- Not categorized 0%
- 1
- 2
- 3
- 4
- 5
- 6
- 7
- 8
- 9
- 10
- Current
- Review
- Answered
- Correct
- Incorrect
-
Question 1 of 10
1. Question
Section 4 of the IPC-A-610 standard includes criteria to verify which of the following conditions: (select all that apply)
CorrectIncorrect -
Question 2 of 10
2. Question
What is the condition for a Class 3 assembly with high power components that have adequate thermal compound that does not interfere with any soldered connections, and insulating washers providing electrical isolation?
CorrectIncorrect -
Question 3 of 10
3. Question
What is the condition for a Class 1 assembly with a heatsink that has no evidence of the required thermal compound?
CorrectIncorrect -
Question 4 of 10
4. Question
What is the condition for a Class 1 assembly with threaded hardware extending 1 thread beyond a nut?
CorrectIncorrect -
Question 5 of 10
5. Question
What is the condition for a Class 2 assembly when the torque stripe is not continuous and looks disturbed?
CorrectIncorrect -
Question 6 of 10
6. Question
What is the condition for a Class 3 assembly when a solid wire is wrapped counterclockwise around a screw head for 270 degrees?
CorrectIncorrect -
Question 7 of 10
7. Question
What is the condition for a Class 3 assembly when a stranded wire is wrapped clockwise around a screw head for 270 degrees and 30% of the conductor diameter protrudes from the screw head?
CorrectIncorrect -
Question 8 of 10
8. Question
What is the condition for a Class 2 assembly when a press fit pin is bent off center by 25% pin thickness?
CorrectIncorrect -
Question 9 of 10
9. Question
What is the condition for a Class 3 assembly with a press fit pin annular ring that is lifted 25% of the annular ring width?
CorrectIncorrect -
Question 10 of 10
10. Question
What is the condition for a Class 1 assembly with a soldered press fit pin that has a solder fillet evident on only 1 side of the assembly’s protrusion side?
CorrectIncorrect