610-M7-Quiz 1

610-M7-Quiz 1

Time limit: 0

Exam Summary

0 of 10 Questions completed

Questions:

Information

You have already completed the exam before. Hence you can not start it again.

Exam is loading…

You must sign in or sign up to start the exam.

You must first complete the following:

Results

Exam complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%

1
2
3
4
5
6
7
8
9
10

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
True or False: Criteria within Section 4 of the IPC-A-610 standard also applies to attachments with self-tapping screws.
- True
- False
Correct

Incorrect
Question 2 of 10

2. Question
What is the condition for a Class 1 assembly that has high power components with uneven solder on mounting holes where an assembly’s fit will be affected?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 3 of 10

3. Question
What is the condition for a Class 2 assembly with a heatsink that is not flush, but has 80% contact with the mounting surface?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 4 of 10

4. Question
True or False: The sharp edges of a lock washer should be against the flat washer.
- True
- False
Correct

Incorrect
Question 5 of 10

5. Question
What is the condition for a Class 3 assembly when split-ring lockwashers are fully compressed?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 6 of 10

6. Question
What is the condition for a Class 1 assembly when a tinned stranded wire is wrapped clockwise around a screw head for 270 degrees?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 7 of 10

7. Question
What is the condition for a Class 2 assembly when a jackpost height is below the connector face resulting in the connector mating correctly?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 8 of 10

8. Question
What is the condition for a Class 1 assembly when an edge connector pin contact is above and not contained within the insulator?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 9 of 10

9. Question
What is the condition for a Class 2 assembly with a soldered press fit pin that has solder wicking of 2.0 mm that does not interfere with pin fit attachments?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 10 of 10

10. Question
What IPC standard contains criteria for wire bundle securing and routing?
- IPC-A-600
- IPC-7711/7721
- IPC-6012
- IPC/WHMA-A-620
Correct

Incorrect