610-M4-Quiz 2

610-M4-Quiz 2

Time limit: 0

Exam Summary

0 of 10 Questions completed

Questions:

Information

You have already completed the exam before. Hence you can not start it again.

Exam is loading…

You must sign in or sign up to start the exam.

You must first complete the following:

Results

Exam complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%

1
2
3
4
5
6
7
8
9
10

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
What is the condition for a Class 2 assembly that has a swaged terminal base of 200 degrees contact with the land with separation not exceeding 2 land thicknesses?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 2 of 10

2. Question
What is the condition for a Class 2 assembly that has 4 radial splits separated by exactly 90 degrees?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 3 of 10

3. Question
What is the condition for a Class 3 assembly that after soldering has a wire with melted insulation?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 4 of 10

4. Question
What is the condition for a Class 2 assembly that has a wire with voids amounting to 10% of the area required to be tinned?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 5 of 10

5. Question
True or False: Wires should be placed in descending order with the largest on top.
- True
- False
Correct

Incorrect
Question 6 of 10

6. Question
What is the condition for a Class 1 assembly when the wire end violates minimum electrical clearance?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 7 of 10

7. Question
What is the condition for a Class 2 assembly when a 30 AWG wire passes through a bifurcated terminal without staking?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 8 of 10

8. Question
What is the condition for a Class 1 assembly that has a wire wrapped and has contact of 180 degrees between the lead and hook terminal post?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 9 of 10

9. Question
What is the condition for a Class 3 assembly that has solder slightly protruding from the solder cup inspection hole?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 10 of 10

10. Question
What is the condition for a Class 3 assembly when a wire end is not discernible on the exit side of a slotted terminal?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect