610-M2-Quiz 2

610-M2-Quiz 2

Time limit: 0

Exam Summary

0 of 10 Questions completed

Questions:

Information

You have already completed the exam before. Hence you can not start it again.

Exam is loading…

You must sign in or sign up to start the exam.

You must first complete the following:

Results

Exam complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%

1
2
3
4
5
6
7
8
9
10

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
What is the condition for a Class 2 assembly that has inclusions projecting from the solder fillet?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 2 of 10

2. Question
True or False: Self-sealing heat shrinkable soldering devices are exempt from cleaning requirements.
- True
- False
Correct

Incorrect
Question 3 of 10

3. Question
What is the condition for a Class 2 high voltage assembly that has discernible solder points?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 4 of 10

4. Question
What is the condition for a Class 1 high voltage assembly that has an insulation clearance of 2 wire diameters?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 5 of 10

5. Question
What is the condition when solder coats a surface then immediately recedes leaving mounds of solder that are separated but not exposing basis metal?
- Cold/Rosin Connection
- Nonwetting
- Bridging
- Dewetting
Correct

Incorrect
Question 6 of 10

6. Question
What is the maximum wetting angle if the solder contour does not extend over the solderable termination area?
- 45°
- 90°
- 120°
- 180°
Correct

Incorrect
Question 7 of 10

7. Question
What is the condition for all classes of assembly if the solder coverage does not meet termination requirements?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 8 of 10

8. Question
What is the condition for a Class 2 assembly that has a solder splash encapsulated on the solder mask that does not violate minimum electrical clearance?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 9 of 10

9. Question
True or False: Lead based (Pb) solder alloys are most likely to result in a surface appearance with cooling lines.
- True
- False
Correct

Incorrect
Question 10 of 10

10. Question
What is the condition for a Class 3 assembly with probe marks that do not violate other requirements?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect