610-M1-Quiz 4

610-M1-Quiz 4

Time limit: 0

Exam Summary

0 of 10 Questions completed

Questions:

Information

You have already completed the exam before. Hence you can not start it again.

Exam is loading…

You must sign in or sign up to start the exam.

You must first complete the following:

Results

Exam complete. Results are being recorded.

Results

0 of 10 Questions answered correctly

Your time:

Time has elapsed

You have reached 0 of 0 point(s), (0)

Earned Point(s): 0 of 0, (0)
0 Essay(s) Pending (Possible Point(s): 0)

Categories

Not categorized 0%

1
2
3
4
5
6
7
8
9
10

Current
Review
Answered
Correct
Incorrect

Question 1 of 10

1. Question
What part of a circuit card should be handled?
- Connectors
- Edges
- Solderable surfaces
- Largest components
Correct

Incorrect
Question 2 of 10

2. Question
What maximum referee would you use for a 30 AWG wire?
- 1.75X
- 4X
- 10X
- 20X
Correct

Incorrect
Question 3 of 10

3. Question
If an inspector is unable to find a defect at the inspection range but decides to increase it to the maximum referee power and finds a defect, then the assembly is considered what?
- Acceptable
- Process Indicator
- Defect
- Not Established
Correct

Incorrect
Question 4 of 10

4. Question
Is IPC-A-610 required for commercial off the shelf (COTS) products?
- Yes
- No
- Typically no, unless contractually agreed upon between the manufacturer and user
Correct

Incorrect
Question 5 of 10

5. Question
If a product is defective for Class 2, it means what?
- It is only defective for Class 2.
- It is also defective for Class 1.
- It is also defective for Class 3.
- It is also defective for Class 1 and Class 3.
Correct

Incorrect
Question 6 of 10

6. Question
When shall an inspector take actual measurements to verify dimensions?
- Never
- During inspection
- During referee
- During inspection and referee
Correct

Incorrect
Question 7 of 10

7. Question
In the event of a discrepancy, what takes precedence in the IPC-A-610 standard?
- It depends on the discrepancy. Sometimes the description or written criteria takes precedence, and sometimes the illustrations take precedence
- Always the illustrations
- Always the description or written criteria
Correct

Incorrect
Question 8 of 10

8. Question
Which of the statements are true regarding conductor diameter and wire diameter? (choose all that apply)
- Conductor diameter does not include the insulation
- Conductor diameter does include the insulation
- Wire diameter does include insulation
- Wire diameter does not include insulation
Correct

Incorrect
Question 9 of 10

9. Question
What side of the board is the solder source side when using through-hole technology?
- Primary side
- Secondary side
- Tertiary side
- Quaternary side
Correct

Incorrect
Question 10 of 10

10. Question
Is “Not Established” a condition within the IPC-A-610 standard?
- Yes
- No
- Yes, but it depends on the criteria
Correct

Incorrect